This model utilises two white filaments of different TDs to achieve the smooth transitions you see in the image attached. I used both a low TD and high TD white for this, so for best results, you should use something similar too!

Print Instructions

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.2mm

Filaments Used:

• PLA Kingroon Black Transmission Distance: 0.4
• PLA+ eSun Grey Transmission Distance: 1.4
• PLA Sunlu Beige Transmission Distance: 8.2
• PLA Kingroon White Transmission Distance: 8
• PLA BambuLab Basic Jade White Transmission Distance: 5

Swap Instructions:

• Start with Black
• At layer #19 (0.92mm) swap to Grey
• At layer #22 (1.04mm) swap to Beige
• At layer #32 (1.44mm) swap to White
• At layer #39 (1.72mm) swap to Jade White for the rest.

If you'd like to support me, I now have a Patreon!

Joining will give you behind the scenes information on WIPs, access to a private discord, early access AND exclusive models!

If you want to sell any physical models I have uploaded anywhere, an unrestricted commercial license is available on the $10AUD tier of my Patreon!